Hi
(not sure if nesting is strictly the right term). I have a part to profile out of acrylic sheet. The part has several internal holes that need to be milled before the outside is cut (eg the gasket example in the sample tutorial that comes with CAM 2.0).
Can the internal holes be forced to cut before the outer profile? Or do I have to have these on separate sketches?
Thanks
(not sure if nesting is strictly the right term). I have a part to profile out of acrylic sheet. The part has several internal holes that need to be milled before the outside is cut (eg the gasket example in the sample tutorial that comes with CAM 2.0).
Can the internal holes be forced to cut before the outer profile? Or do I have to have these on separate sketches?
Thanks