progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#273 by andersen
Sun Oct 26, 2008 8:38 pm
me again...
i've got some problems with several drawings.
i'm constructing 2d, but many lines have 3d coordinates (z = 6.00m f.ex.), others are on level 0.00m, others start from 3.00 and go up to 4.91m...so that it is impossible to stretch, trim or use the correct entity snap (especially perpendicular isn't possible when the lines are so strange...).
Another example: i pasted a block from another drawing, just a line, a circle, and a number in the circle. Why is the number with z=0.00, but the line on 3.00 and the circle on 4.50??? in the original drawing everything is correct...
what's going wrong with my drawings? what's the solution???!
#275 by caddit
Mon Oct 27, 2008 11:18 am
Hi andersen,


Have you already tried the "flatten" command?

I might be confused by the statement "Why is the number with z=0.00". If your problems continue, please send an example drawing to:
Image

And we will respond back here on this forum after looking at your CAD file.

Hope that helps.