progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#2215 by swinny
Sat Feb 07, 2015 1:06 am
My drawing, along with the x and y axis have reversed 180 degrees. This is only in the main model space. When I go to a paper space tab the drawing displays correctly both in model and paper space.

How can I get my drawing back to the right direction? The mirror command does not do the trick as it then displays in reverse in the paper space tab.

#2216 by caddit
Mon Feb 09, 2015 6:44 am
Dear swinny,

Sounds like the whole model viewpoint was somehow rotated 180 degrees about the Y axis.

Switch it back with View->Predefined->Top.

In other words, what you report to see in paper space demonstrates that the actual geometry hasn't changed - only your way of looking at it in model space has.