Hello all
I am using ProgeCAD smart 2009 9.0.28.8
The Object Snaps toolbar seems to indicate the current snap state OK but clicking the buttons causes an 'unable to recognize command' error. For example the perpendicular snap uses _PER which is not recognized. Is there a way to correct this?
Thanks.
I am using ProgeCAD smart 2009 9.0.28.8
The Object Snaps toolbar seems to indicate the current snap state OK but clicking the buttons causes an 'unable to recognize command' error. For example the perpendicular snap uses _PER which is not recognized. Is there a way to correct this?
Thanks.