progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#1583 by obe1
Mon Aug 08, 2011 11:52 am
I work with drawings from a large number of sources (surveyor, architect, services, in house from various disciplines, etc). When I xref these into my drawings I get slow performance or mixed scales, etc.

Do you have recommendations on setting up drawings for use as XREF's?

I work with a large number of drafters and there seems to be no rhyme or reason.

Thanks

#1590 by caddit
Wed Aug 10, 2011 10:05 am
Hello obe1,


Good question.

For the contract draftsman it is sometimes very difficult to "consolidate" drawings done up to different standards and requirements from different customers ~ ~ Obviously maintaining data to customers' specification is primary, and internal systems of consolidation secondary (i.e. "customer service")

I'm going to leave this topic sticky for a bit, because I think it might make for interesting feedback and discussion from our other users ~ lets see how this goes...


May the force be with you all..