progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#126 by plans2go
Tue Jun 03, 2008 3:28 am
In ProgeCAD can you remove the unwanted "Z" values from a group of existing lines
previously the properties box gave you z values & you simply changed them from "Varies" to zero
#127 by caddit
Tue Jun 03, 2008 8:13 am
progeCAD now supports two properties dialogue boxes. The side properties palette to the left side is raised using the _properties command. The Z coordinates for individual entities can still be seen using the older _entprop dialogue box for multiple entities having a common Z value, or single select.

If you just want to reduce Z value for several entities at one time to zero, use the _flatten command.