As a Progecad Smart user I am pleased with the program, but have found someproblems. They have been posted onto the Progesoft Smart forum page but as this is un-moderated thought that it would be a good idea to post here as well.
The two that spring to mind are
1). Snap to paralell doesnt work. We can use Offset so this isnt too bad
2). Unable to print line weights even though they are set in properties. This is a problem.
The two that spring to mind are
1). Snap to paralell doesnt work. We can use Offset so this isnt too bad
2). Unable to print line weights even though they are set in properties. This is a problem.