progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#2422 by fging
Thu May 20, 2021 1:50 pm
I am encountering a problem with copybase command as it does not use the base point selected. It asks for the base point, but does not consider it when pasting the entities. As a reference, check Autocad LT 2015 behavior.
I have been using Progecad for years now and the same issue has never been fixed nor discussed in time.
#2423 by jouni
Thu Jun 03, 2021 11:26 am

Have you tried COPYBASE and the PASTEORIG? It does not work if you just PASTE.
This has always behaved as it is meant.
Progecad 2006-2020.

#2424 by fging
Mon Jun 07, 2021 8:05 pm
Thank you very much. I thought that it was the same as Autocad.
#2425 by fging
Mon Jun 07, 2021 8:28 pm
I tried to find this pasteorig command from HELP menu, but it does not exist. Where can I find the definition of such commands ?
#2426 by fging
Tue Jun 15, 2021 7:29 pm
Hi again Jouni,

after numerous tests, it is definitely Copybase in ProgeCADthat does not work properly. Pasteorig is intended to paste in relationship with the origin of the drawing from which come the copied entities. If ever you copybase with a different basepoint than the origin, pasteorigin will paste according to the origin, not according to that different basepoint.

I tried many ways to paste according to the selected base point and I never succeded.

Try copybase in Autocad and paste it (with windows paste command, which is a very handsome procedure) and it will always paste according to the selected base point.

I would like to advise CADDIT about this bug.