progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#2422 by fging
Thu May 20, 2021 1:50 pm
I am encountering a problem with copybase command as it does not use the base point selected. It asks for the base point, but does not consider it when pasting the entities. As a reference, check Autocad LT 2015 behavior.
I have been using Progecad for years now and the same issue has never been fixed nor discussed in time.
#2423 by jouni
Thu Jun 03, 2021 11:26 am
Hello

Have you tried COPYBASE and the PASTEORIG? It does not work if you just PASTE.
This has always behaved as it is meant.
Progecad 2006-2020.

Jouni
#2424 by fging
Mon Jun 07, 2021 8:05 pm
Thank you very much. I thought that it was the same as Autocad.
#2425 by fging
Mon Jun 07, 2021 8:28 pm
I tried to find this pasteorig command from HELP menu, but it does not exist. Where can I find the definition of such commands ?