Hello,
as I tried to draw some polygones using the commandbar (input as string "_PLINE x,y x,y ... x,y s _PLINE..." and so on) i noticed, that ProgeCADs command bar only accepted 9721 characters as input and stoped there, cutting the rest of the string.
Furthermore ProgeCAD needed very long for the drawing task (around 4 Sec without hardware acceleration, around 10 with, at 9721 characters) in comparison to AutoCAD where the drawing happend semmingly instantanious (for the complete string) although it was cut to single lines with:
" _pline
x,y
x,y
...
x,y
end
_pline
..."
which seems not possible for ProgeCAD. (Thats why the string was written to one line and how I discovered the boundary of the command bar)
My Questions are:
Is it possible to enlarge/modifiy the capacity for characters in th command bar?
And why is drawing without hardwareacceleration so much faster?
Thanks
Zerow
as I tried to draw some polygones using the commandbar (input as string "_PLINE x,y x,y ... x,y s _PLINE..." and so on) i noticed, that ProgeCADs command bar only accepted 9721 characters as input and stoped there, cutting the rest of the string.
Furthermore ProgeCAD needed very long for the drawing task (around 4 Sec without hardware acceleration, around 10 with, at 9721 characters) in comparison to AutoCAD where the drawing happend semmingly instantanious (for the complete string) although it was cut to single lines with:
" _pline
x,y
x,y
...
x,y
end
_pline
..."
which seems not possible for ProgeCAD. (Thats why the string was written to one line and how I discovered the boundary of the command bar)
My Questions are:
Is it possible to enlarge/modifiy the capacity for characters in th command bar?
And why is drawing without hardwareacceleration so much faster?
Thanks
Zerow