Hi,
Next issue for me is the correct setting for angular units.
By default i understand ProgeCAD works with a mathematical angular base where the angles increase anticlockwise with 0 to the right (east). My preference as a surveyor is clockwise with the 0 to the top (north). The clockwise setting works fine, but when i set 90 degrees in the "angular base" field, i have issues with the placement of text and blocks rotating incorrectly. Example when i place text in the direction of 90 degrees (so the text reads upright and normal) the text displays on screen vertically in the direction of north. When placing a block (say a north arrow) i set the placement angle to 0 and the block comes out facing east.
When i select a line on the scree, the properties show that the line has the expected and correct "bearing."
Additionally the setting of this in the drawing properties seems buggy, when i enter 90 using the keyboard and close the settings, i re-open the dialogue to find the setting is now 270. If i use the software up and down buttons it seems to remain as input at 90.
I believe this function is buggy, as it does not perform as expected at all.
Cheers,
Tyson
Next issue for me is the correct setting for angular units.
By default i understand ProgeCAD works with a mathematical angular base where the angles increase anticlockwise with 0 to the right (east). My preference as a surveyor is clockwise with the 0 to the top (north). The clockwise setting works fine, but when i set 90 degrees in the "angular base" field, i have issues with the placement of text and blocks rotating incorrectly. Example when i place text in the direction of 90 degrees (so the text reads upright and normal) the text displays on screen vertically in the direction of north. When placing a block (say a north arrow) i set the placement angle to 0 and the block comes out facing east.
When i select a line on the scree, the properties show that the line has the expected and correct "bearing."
Additionally the setting of this in the drawing properties seems buggy, when i enter 90 using the keyboard and close the settings, i re-open the dialogue to find the setting is now 270. If i use the software up and down buttons it seems to remain as input at 90.
I believe this function is buggy, as it does not perform as expected at all.
Cheers,
Tyson