I have upgraded from ProgeCAD 2010 USB to 2013 USB.
PROGECAD 2010: If i copy an entity and paste it, with ortho enabled, the pasted entity is constrained to the same alignment X or Y as the source entity that was copied.
PROGECAD 2013: If i copy an entity and paste it, with ortho enabled, the pasted entity is NOT constrained to the same alignment X or Y as the source entity that was copied and goes anywhere. What am I missing here please?
PROGECAD 2010: If i copy an entity and paste it, with ortho enabled, the pasted entity is constrained to the same alignment X or Y as the source entity that was copied.
PROGECAD 2013: If i copy an entity and paste it, with ortho enabled, the pasted entity is NOT constrained to the same alignment X or Y as the source entity that was copied and goes anywhere. What am I missing here please?