progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#12 by tonyod
Tue Feb 05, 2008 1:57 am
Has anyone else noticed that since updating to 8.0.14, trim and extend have reduced performance rather than the as claimed improved performance?
#13 by jk
Tue Feb 05, 2008 2:37 am
I haven't noticed a difference, but we just do simple things in class. Can you tell us what you're doing when you get "reduced performance"?
Last edited by jk on Wed Feb 06, 2008 5:31 am, edited 1 time in total.
#15 by caddit
Tue Feb 05, 2008 3:36 am
tonyod,


Can you please give us more information about your problem? It would be best if you can tell us what hardware/graphics-card setup you have, what kind of DWG file(s) you are editing (if they have nested blocks, how big etc) and steps for repeating the problem.

Regards,
Ben

#17 by tonyod
Fri Feb 08, 2008 3:18 am
Hi Ben,

2.8GHz Intel Celeron, 1GB RAM, Intel 82945G graphics.

Drawing size was 1695k, several blocks - none embedded.

Extend to nearest took 13 seconds after selecting line before another command could be entered.

Purging some blocks resulted in a 827k drawing. Extend took 12 seconds.

Purging all - 732k, 6 seconds. Prior to the update the same operation on the same drawing was almost instantaneous.
#22 by progesoft
Mon Feb 11, 2008 10:45 am
This is a known problem and we will fix in next release. I'll give a pre-release to CADDIT to fix this problem quickly