me again...
i've got some problems with several drawings.
i'm constructing 2d, but many lines have 3d coordinates (z = 6.00m f.ex.), others are on level 0.00m, others start from 3.00 and go up to 4.91m...so that it is impossible to stretch, trim or use the correct entity snap (especially perpendicular isn't possible when the lines are so strange...).
Another example: i pasted a block from another drawing, just a line, a circle, and a number in the circle. Why is the number with z=0.00, but the line on 3.00 and the circle on 4.50??? in the original drawing everything is correct...
what's going wrong with my drawings? what's the solution???!
i've got some problems with several drawings.
i'm constructing 2d, but many lines have 3d coordinates (z = 6.00m f.ex.), others are on level 0.00m, others start from 3.00 and go up to 4.91m...so that it is impossible to stretch, trim or use the correct entity snap (especially perpendicular isn't possible when the lines are so strange...).
Another example: i pasted a block from another drawing, just a line, a circle, and a number in the circle. Why is the number with z=0.00, but the line on 3.00 and the circle on 4.50??? in the original drawing everything is correct...
what's going wrong with my drawings? what's the solution???!