progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#2319 by Juanito Crandello
Sat Feb 13, 2016 11:53 am
all of a sudden, after using the program for over a year and creating many numerical dimensions, the program now refuses to stack fractions at an angle, rather than vertical. All previous layout drawings have angular/stacked fractions. The interface that pops up when double clicking a line of text includes nothing/no way to stack - other than vertically. What's a poor landscape architect to do?
#2321 by caddit
Wed Feb 17, 2016 11:08 am
Not sure if this is related to the other problem you have reported or not - did they both come about at the same time?

Does the stacking problem occur even when you start with a anew drawing?

You can try resetting your environment:

For most versions of AutoCAD 2012 and later (including AutoCAD-based products), the reset utility can be found in the AutoCAD program group located in the Windows Start Menu:
* Start menu > All Programs > Autodesk > AutoCAD 201x > "Reset Settings To Default"

Also be sure to run audit/purge on effected drawing files.

Thanks.