progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#2054 by MelatCMC
Tue Sep 03, 2013 3:24 pm
Square to round: I am trying to chamfer the edge of a solid and I keep getting "failure to perform blend". The edge is on a lofted solid which is made from a circle and a square. Its the circle I am trying to chamfer.

#2055 by caddit
Thu Sep 05, 2013 9:16 am
Dear MelatCMC,

Can you confirm which CAD program you are using for this? Which version?

NOTE: Please do this on every post, do not make readers "assume" which CAD program and version you are using, thank you very much.

#2056 by MelatCMC
Thu Sep 05, 2013 3:29 pm
I am using AutoCAD Mechanical 2012