progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#2021 by lalunatech
Thu Jun 06, 2013 7:34 am
Hello all
I am using ProgeCAD smart 2009 9.0.28.8
The Object Snaps toolbar seems to indicate the current snap state OK but clicking the buttons causes an 'unable to recognize command' error. For example the perpendicular snap uses _PER which is not recognized. Is there a way to correct this?

Thanks.