progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#1981 by Hicksy
Thu Feb 28, 2013 12:54 am
Hello Again.
I am having trouble learning how to Chamfer Corners.
How would I go about cutting eg 10mm off a corner or corners of a box?
Some some Templates I have here have chamfered corners & I am doing it the hard way by roughly drawring the chamfer.

#1983 by caddit
Wed Mar 06, 2013 3:15 pm
Dear Hicksy,

What kind of chamfer are you looking for? The progeCAD chamfer command has a few options.

For example, if you know the desired length and angle of the chamfer, start by entering (A)ngle mode, select the two entities to be chamfered and hit enter.

Did you already read the progeCAD Help for chamfer:

Perhaps share a specific scenario you are having trouble with?