My Fuji Xerox A4 printer has a facility to print in banner, IE, across 4 x A4 sheets with crop marks adn we tape these together to get a large A2 drawing. Progecad 2011 coped well with it, but the 2013 version only prints it as 1 x A4 sheet only even when set up as a banner. Why?
I have reinstalled the3 2011 version just to print teh drawings.
Also, my Help Menu (top left) has reverted back to the simple 4 line 2011 version?? When originally installed, 2013 had a whole column of drop
down lines with "check for Updates", etc. I notice this happened after my PC suspended when I left the office. On awakening the PC,
the menu colour theme changed to blue??? I had to close Progecad and reopen it to get the black colouring back, but the
Help menu stayed as the simple 4 line version. What's up?
Oh, ProgeCAD 2013 is way better the 2011, much faster on complex drawings, where 2011 would often just crash.
Thanks Steve
I have reinstalled the3 2011 version just to print teh drawings.
Also, my Help Menu (top left) has reverted back to the simple 4 line 2011 version?? When originally installed, 2013 had a whole column of drop
down lines with "check for Updates", etc. I notice this happened after my PC suspended when I left the office. On awakening the PC,
the menu colour theme changed to blue??? I had to close Progecad and reopen it to get the black colouring back, but the
Help menu stayed as the simple 4 line version. What's up?
Oh, ProgeCAD 2013 is way better the 2011, much faster on complex drawings, where 2011 would often just crash.
Thanks Steve