I have 2 drawings, both created in this installation of profeCAD11 on the same computer.
One drawing works as expected - that selection of non-continuous line types are rendered correctly on the screen and in the printed version.
In the same session if you open the other drawing, set a line type to a non-continuous line type, say DASHED2, that value is also seen in that PolyLine's linetype property. but the line is always rendered as a continuous line.
Comparing the view of the 2 drawings in the same session shows that there is something wrong with the linetype selectors in one drawing compared with the other. Normally in the Properties and in the current line type value selector (toolbar area) a graphic is drawn to the left of the line type name. However for the drawing that only renders non-continuous lines as continuous, this graphic pattern is always blank.
What setting has to be changed so that non-continuous line types are rendered correctly in the second drawing?
One drawing works as expected - that selection of non-continuous line types are rendered correctly on the screen and in the printed version.
In the same session if you open the other drawing, set a line type to a non-continuous line type, say DASHED2, that value is also seen in that PolyLine's linetype property. but the line is always rendered as a continuous line.
Comparing the view of the 2 drawings in the same session shows that there is something wrong with the linetype selectors in one drawing compared with the other. Normally in the Properties and in the current line type value selector (toolbar area) a graphic is drawn to the left of the line type name. However for the drawing that only renders non-continuous lines as continuous, this graphic pattern is always blank.
What setting has to be changed so that non-continuous line types are rendered correctly in the second drawing?