Been working in R14 for years so I am behind the curve,
For user variable return I have always used....
!variablename>enter
For instance...
In Progecad...
if I type at the command line...
(setq test 1000)
If I want to check the value of the user variable "test" in R14 at the command line I just type !test>enter
R14 would then return 1000
This does not seem to work on progecad 11.
What is the command in progecad ??
Thanks
For user variable return I have always used....
!variablename>enter
For instance...
In Progecad...
if I type at the command line...
(setq test 1000)
If I want to check the value of the user variable "test" in R14 at the command line I just type !test>enter
R14 would then return 1000
This does not seem to work on progecad 11.
What is the command in progecad ??
Thanks