PDF export just produced nothing after giving the PDF a name. I found that the PDF writer was not installed. Install progeCAD about 3 weeks ago W7 64bit 12Gb ram.
I found a message on the forum about this for progeCAD 2010, so I tried the same procedure. However, after installing it using PDFADD/install.exe I get Amyuni Document Converter in my printers list (GOOD). But when I try to print a test page from it I get
"Printer not activated, error -41"
I could not find where to get the progeCAD PDF Printer Properties page suggested in the previous message.
What next?
I found a message on the forum about this for progeCAD 2010, so I tried the same procedure. However, after installing it using PDFADD/install.exe I get Amyuni Document Converter in my printers list (GOOD). But when I try to print a test page from it I get
"Printer not activated, error -41"
I could not find where to get the progeCAD PDF Printer Properties page suggested in the previous message.
What next?