progeCAD 2011 recently downloaded and installed XP SP2.
Create a closed 3dpolyline in one layer.
Set another layer as current.
Select that 3dpolyline as boundary region.
use "bhatch" to fill that 3dpolyline in this second layer.
both the the first layer and the second layer are set to be visible.
Set hatch as associated with boundary.
On OK the original 3Dployline is not visible nor is the hatched region.
What have I set wrongly?
Create a closed 3dpolyline in one layer.
Set another layer as current.
Select that 3dpolyline as boundary region.
use "bhatch" to fill that 3dpolyline in this second layer.
both the the first layer and the second layer are set to be visible.
Set hatch as associated with boundary.
On OK the original 3Dployline is not visible nor is the hatched region.
What have I set wrongly?