progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#1393 by Jagdtiger
Wed Dec 08, 2010 11:03 pm
When I insert a block I am no longer prompted for attribute values. This was working fine until today.

Has anyone else had this problem or is their a setting for turning the prompting ON/OFF.

Any help would be appreciated
#1398 by caddit
Wed Dec 15, 2010 12:44 pm
Hello Jagdtiger,

This behaviour to prompt for block attributes is controlled by two variables:

ATTREQ - Uses the setting for ATTDIA and prompts the user for values either by command line or dialog box. SET TRUE.

ATTDIA - Set TRUE if you want to be prompted with a dialogue box instead of from the progeCAD command prompt.

#1400 by Jagdtiger
Wed Dec 15, 2010 9:27 pm

I don't know how ATTREQ got turned off, but everything is OK now.