progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#1060 by seasdes
Sat May 15, 2010 3:16 am
I am getting the following error messages when i do a Save & Save As.
Any ideas what might be causing it.

"Progecad is still waiting for response from one of the printers.
Press ignore to go on saving (you may lose some printers information).
Press Abort to stop saving.
Press retry to try again."


"One or more printers are not responding. The drawing will be saved without some printer information. Please verify your printers settings on the Operating Systems control panel and their drivers status. If you need help please contact the technical support at support_eng(at)progesoft.com"


Seasdes

#1067 by seasdes
Mon May 17, 2010 9:21 pm
I have no idea as to the printer causing the problem. PDF Factory Pro does not work properly with Progecad. It works fine with all of my other software.
The Progecad PDF driver is the printer usually connected to Progecad.
Clip of all printers om my system sent to you by email.
Seasdes[/img]

#1077 by seasdes
Tue May 18, 2010 10:06 pm
I do not know.
How do I remove the Progecad pdf driver. I need the PDF Factory driver.
Seasdes

#1078 by seasdes
Tue May 18, 2010 10:27 pm
In an effort to fix this problem I uninstalled Progecad 2010 then reinstalled it.
N I get this message
"progeCAD 2010 Application has encountered a problem and needs to close. We are sorry for the inconvenience"
What do I do now?
Seasdes