progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#1032 by disegno
Sat Apr 17, 2010 12:45 am
2D Drawing
If I do a list on the dimensions on my drawing the results show a rotation of approximately 1.5 degrees.
How did this happen since I thought that all of my lines were horizontal and vertcal and the UCS was set to 'world' and the 'view' was set to 'top'?
#1034 by caddit
Mon Apr 19, 2010 5:11 pm
Hello disegno,


Not sure about this in 2009 (we are using 2010 here now). I suggest that you send a drawing with a screen shot of the problem behaviour as appears in 2009 and we can check for the same in 2010 and maybe suggest an explanation, if we can reproduce the problem here:

http://www.caddit.net/image/e-ad.jpg