One very useful feature i can't seem to use in ProgeCAD is the "inferencing".
It's generally guides without really making lines, just by hovering through an endpoint, you'll establish somewhat like a grip to help in projecting.
Same with the ESNAP, i can't seem to get the size of an unknown radius because the "center snap" doesn't show. It's usually when you try to measure the size of a filleted corner with a radius. i have no problems with the perfect circles though.
Thanks again!
It's generally guides without really making lines, just by hovering through an endpoint, you'll establish somewhat like a grip to help in projecting.
Same with the ESNAP, i can't seem to get the size of an unknown radius because the "center snap" doesn't show. It's usually when you try to measure the size of a filleted corner with a radius. i have no problems with the perfect circles though.
Thanks again!