progeCAD support, tips and troubleshooting forum. progeCAD works very similar to some versions of AutoCAD. Moderated.

Moderators: caddit, Moderators

#70 by rotorsrule
Thu Apr 24, 2008 8:21 am
HELP PLEASE!
>
> I am using ProgeCad for private users. After i updated to 8.018.2 my
> entity snap is not working.
> The snaps of my choise is activated. Format/Entity Snap/Entity Snap
> Settings/Coordinate Input/Snaps of my choise on.
>
> I can not activate the snap settings no matter what i do.

#71 by progesoft
Thu Apr 24, 2008 9:18 am
can you send us an example?

#72 by rotorsrule
Thu Apr 24, 2008 9:36 am
Say i want to snap to the end of a line. As i move over the end of the line the end of line snap must activate. It does not but the snap setting for entities is enabled.

It must snap but does not. No snap works ie middle of line, intersection, quadrant etc.
#73 by jk
Thu Apr 24, 2008 9:47 am
Hiya,


You mean ESNAP? 8.0.18 works great for me! No problems "snapping" at all :)

#74 by progesoft
Thu Apr 24, 2008 9:55 am
Are you working in layout?
#75 by caddit
Thu Apr 24, 2008 10:02 am
Hi rotorsrule,

I think we know what esnap is. rotorsrule, can you please try it with a blank file ("File -> New...") and tell us if it works. If it still doesn't we will need a screen shot of your eSnap dialogue box and so forth. What is the value of your IntelliCAD "OSMODE" system variable when you try it?

If you only have this problem with a certain file, we will need to see the file like progesoft already said.

#76 by rotorsrule
Thu Apr 24, 2008 10:51 am
Hi,

I am working in MODEL view.

I did use new drawing and various of my previous exersices. Snap not working.

Uninstalled and reinstalled, snaps not working.

Uninstalled and installed older version 8.0.11. Snaps working.

Sorry i uninstalled before i read your post. Will reinstall later and then send you a screenshot.

Thank you for the promt response.

#80 by rotorsrule
Thu Apr 24, 2008 11:43 am
Please explain to me where i can read the OSMODE variable. :?

Thanks,

#82 by slim
Thu Apr 24, 2008 12:12 pm
You find the OSMODE setting by typing OSMODE on the comand line prompt.

#84 by progesoft
Thu Apr 24, 2008 12:14 pm
Do you have a SMART version ?

the problem has been reproduced on Smart and that we are looking into a fix shortly. This only affects progeCAD Smart

#85 by rotorsrule
Thu Apr 24, 2008 12:25 pm
Hi,

Yes it is the SMART version.

Regards, :D