Page 1 of 1

T-Flex errors in very simple drawing - bug?

PostPosted:Wed Mar 21, 2012 7:12 am
by Tonez
The following problem happens on my Windows 7 (64 bit) with T-Flex 11.

I am trying to create a fragment from an existing assembly drawing and I get this whenever I try to save the fragment.

Image

It's a very simple drawing (done purely to test for this problem). A simple extruded rectangle saved as a 3d model.

Then, using File -> Fragment -> Create I create the fragment file. It allows me to save this (so far empty) file OK.

Then I draw something over top of the main part greyed out in the background - and the error then comes when I try to save the drawn fragment.

If I continue with the save, and then try to open the fragment, nothing is there.

Any ideas?

PostPosted:Thu Mar 29, 2012 1:08 pm
by caddit
Dear Tonez,


We cannot duplicate the error using the latest upgrade to T-FLEX version 11.

It is possible that this may be a bug that was fixed in a later version, which upgrade release of version 11 do you have?

My T-Flex version

PostPosted:Thu Mar 29, 2012 1:15 pm
by Tonez
It's 11.0.16.0, Dec 25 2007.