Page 1 of 1

Error opening prototype model file

PostPosted:Fri May 08, 2009 2:16 pm
by wallclimber85
When I try to create a new 3d model I get the following error: "error opening prototype model file"
c:\program files\t-flex\t-flex parametric cade 11\program\template\ansi 3d front right bottom workplanes.grb
Any ideas?

PostPosted:Mon May 11, 2009 7:39 am
by caddit
Hi,


Are you able to go and check on your hard disk to see if
c:\program files\t-flex\t-flex parametric cade 11\program\template\ansi 3d front right bottom workplanes.grb
exists? Also make sure that you have full access permission (read/write)

Something may have gone wrong with the install, you may try to install again and see if that helps.

PostPosted:Thu May 21, 2009 2:27 pm
by wallclimber85
The file isnt there. Where can i get it? or should i just reinstall?

Missing Template File in T-FLEX PLM

PostPosted:Fri May 22, 2009 12:41 am
by caddit
HI wallclimber85,


Log in as administrator and uninstall all T-FLEX software. Then re-install from the downloaded installer on you hard disk.