MATHCAD, Geomagic Freeform, Mecsoft VisualCAM & CAD CAM CNC software support discussion forum. Moderated.

Moderators: caddit, evanish, Moderators

#603 by wallclimber85
Fri May 08, 2009 2:16 pm
When I try to create a new 3d model I get the following error: "error opening prototype model file"
c:\program files\t-flex\t-flex parametric cade 11\program\template\ansi 3d front right bottom workplanes.grb
Any ideas?

#613 by caddit
Mon May 11, 2009 7:39 am
Hi,


Are you able to go and check on your hard disk to see if
c:\program files\t-flex\t-flex parametric cade 11\program\template\ansi 3d front right bottom workplanes.grb
exists? Also make sure that you have full access permission (read/write)

Something may have gone wrong with the install, you may try to install again and see if that helps.

#635 by wallclimber85
Thu May 21, 2009 2:27 pm
The file isnt there. Where can i get it? or should i just reinstall?